Cembre B35-50MA Manual De Uso página 6

ENGLISH
2.4) Release of dies
Press the pressure release button (9), the ram will retract and open the dies.
2.5) Head rotation
For ease of operation the tool head can rotate through 180°, allowing the operator to work in the
most comfortable position.
Warning: do not attempt to rotate the head when the hydraulic circuit is pressurised.
2.6) Replacement of dies
To replace the dies, open the head and extract them from their seats.
2.7) Battery status
The battery is equipped with LED indicators that indicate the remaining battery life at any time by
pressing the adjacent button (P).
4 LEDs illuminated: Fully charged
2 LEDs illuminated: 50 % capacity
1 LED fl ashing: Minimum charge, replace the battery
2.8) Insertion/replacement of battery
To replace the battery, remove it by pressing the release button (15) (Ref. to Fig.5 page 24), then
insert the new battery, sliding it into the guides until it locks.
3. WARNING
Before starting work on electrical equipment, please ensure that either there are no live parts in
the immediate working area or that precautions are taken for working near live parts in accordance
with EN50110-1.
D
O NOT USE THIS TOOL ON OR NEAR ENERGIZED CONDUCTORS WITHOUT PROPER
PERSONAL PROTEC TIVE EQUIPMENT
RESULT IN SEVERE INJURY OR DEATH
T
HE TOOL IS UNSUITABLE FOR CONTINUOUS USE AND SHOULD BE ALLOWED TO
COOL DOWN FOLLOWING UNINTERRUPTED
,
INSTANCE HAVING EXHAUSTED A FULLY CHARGED BATTERY IN ONE SESSION
BATTERY REPLACEMENT FOR A FEW MINUTES
O
BSERVE RECOMMENDED REST PERIODS ALSO WHEN USING AN EXTERNAL POWER
.
SUPPLY
P
ROTECT THE TOOL FROM RAIN AND MOISTURE
. E
AND BATTERY
RAIN OR UNDER WATER
(Ref. to Fig. 3)
.
-
LECTRO HYDRAULIC TOOLS SHOULD NOT BE OPERATED IN POURING
.
.
FAILURE TO OBSERVE THIS WARNING COULD
,
SUCCESSIVE CRIMPING OPERATIONS
.
. W
ATER WILL DAMAGE THE TOOL
2
P
FIG. 3
;
FOR
,
DELAY
6