Technical Data - GAPOSA QC09 Manual De Instrucciones

QC 09
Remote Control Unit for shutters and awnings
IMPORTANT: READ CAREFULLY THESE INSTRUCTIONS
- In case of doubts about the installation, contact a qualified technician
- Disconnect supply during installation or whatever maintenance on the control
QC09 control unit for shutters and awnings is provided with a redio receiver (434,15MHz) and a
facility for a pushbutton and a wind sensor. It is in a water resistant box with an internal antenna.

TECHNICAL DATA

Power supply
Max. motor power
Frequency
The receiver can record up to 31 different codes to identify as many transmitters.
The shutter/awning is controlled by a transmitter and/or an external standard switch (normally
open). You can also install a wind sensor QCWS/QCWSRI/QCWSSRI (option) which closes the
awning automatically in case of strong wind.
The transmitter has a range of 20 mt. indoor and 100 m. outdoor.
Max. distance between wind sensor and QC09 is 30 m.
ATTENTION: If you install several QC09 in the same room, during the first
installation you will have to supply and set each unit at a time in order to avoid
any interference (loss of programming or rotation inversion).
COMPATIBLE
TRANSMITTERS
230VAC 50-60Hz
500W
434,15 MHz
QCTD QCT6 QCT1
Dimensions
Weight
IP
QCT3S QCT34S
133X35X25mm
100g
55
5