HAMPTON BAY JAQ1501L-2/CRAC Guía De Uso Y Mantenimiento

PACKAGE CONTENTS
A – Lamp Body x1 B – Post x1
Assembly and Installation
1
Attaching and installing the light
WARNING: Never push the fixture into the ground by the lamp body (A)
or use a hammer to insert the ground stake (D) into the ground.
Screw the post (B) onto the lamp body (A).
□
Insert the fixture wire on the wire connector (C) into the groove located on
□
the top of the ground stake (D).
Screw the ground stake (D) into the post (B). Ensure the fixture wire on
□
the wire connector (C) stays in the center of the groove of the ground
stake (D) to avoid damage to the fixture wire.
Prepare a hole in the installation location. Use a tool such as a
□
screwdriver (not included) to prepare the installation hole to ensure that
the hole is not larger than the ground stake (D).
Install the fixture in the ground by pushing on the foot step (1) on the
□
ground stake (D). Do not push on the lamp body (A).
C – Wire Connector (with 12 in. wire attached to lamp body) x1
2
1
Use and Care Guide
LED LOW VOLTAGE PATH LIGHT
Connecting the wires
WARNING: The wire connector (C) contacts have sharp edges for
piercing the main low voltage cable. To avoid injury, do not touch the
metal contacts.
CAUTION: The wire from low voltage power unit should be 12-16 AWG
type underground low Energy Circuit Cable.
IMPORTANT:
Protect the wiring by routing it in close proximity to the light fitting,
□
or next to a building structure such as a house or a deck.
The landscape wire and connector can also be hidden under stone
□
or buried under grass at a maximum depth of 6 in. (15.24 cm).
Do not install the fixture within 10 ft. of a pool, spa, or fountain.
□
Do not submerge the fixture in water.
□
Place the wire connector (C) on opposite sides of the low voltage
□
cable (not included) from the transformer (not included) where the
fixture will be located.
Align and fit the main low voltage cable vertically to the slot of the
□
wire connector (C).
Press the wire connector (C) together until it is locked around the
□
main low voltage cable. The pre-set prongs will pierce the cable
insulation and establish contact with the electrical wire inside.
Once the wire connector (C) is in place, it is recommended to wrap it
□
with electrical tape (not included).
After all fixtures are installed, turn on the transformer.
□
Item #1002 669 670
Model #JAQ1501L-2/CRAC
Item #1002 669 696
Model #JAQ1501L-2/FROS
D –Ground Stake (6.693 in.) x1