HAMPTON BAY JAO1691L Guía De Uso Y Mantenimiento

PACKAGE CONTENTS
A – Fixture x1 C – Wire Connector (with 36 in. wire) x1
B – Female Plug (with 12in. wire) x1
Template x1
Assembly and Installation
Installing the fixture with the wire routed behind the
1
mounting surface
NOTE: This document provides two different methods for routing
the lead wire. You can chose which method best fits your needs.
□ Place the cardboard template (CC) on the mounting surface and mark
where the holes should be for the female plug (B) and the self-threading
screws (AA).
□ Use at least a 7/16 in. drill bit to drill a hole on the surface large enough
for the female plug (B) to pass through the hole on the mounting surface.
□ Insert the female plug (B) through the hole on the mounting surface.
□ Insert the male plug (D) into the female plug (B).
□ Place the fixture (A) against the mounting surface.
□
Use a Phillips screwdriver to screw the self-threading screws (AA)
through the two holes on the fixture (A) to secure the fixture (A) to the
mounting surface.
CC
C
D – Male Plug x1
D
AA
AA – Self-Threading
Installing the fixture with the wire on front of
1
the mounting surface
□ Place the cardboard template (CC) on the mounting surface and
mark where the holes should be for the self-threading screws
(AA).
□ Insert the male plug (D) into the female plug (B).
□ The wire plugs may be retained inside the back of the fixture (A)
by coiling the wire and plugs and dropping the wire through the
notch in the bottom of the fixture (A).
□ The wire plugs may be left outside the fixture (A) by dropping the
wire through the notch in the bottom of the fixture (A) with the
plugs outside the back plate when the fixture is mounted. The
connected plugs are waterproof.
□ Place the fixture (A) against the mounting surface.
□
Use a Phillips screwdriver to screw the self-threading screws
(AA) through the two holes on the fixture (A) to secure the fixture
(A) to the mounting surface.
A
AA
B
D
A
AA
AA
A
B
B
D
D
1
Item #1002 669 230
Model #JAO1691L
Use and Care Guide
LED LOW VOLTAGE
SURFACE MOUNT LIGHT
BB
BB – Plastic
Screw (40 mm) x2 Anchor (25 mm) x2
Or
CC
CC
CC – Cardboard