HAMPTON BAY JAO1501L-2 Guía De Uso Y Cuidado

PACKAGE CONTENTS
A – Lamp Body x1 B – Ground Stake (6.535 in.) x1
Assembly and Installation
1
Attaching and installing the light
WARNING: Never use a hammer to insert the light into the ground.
Insert the fixture wire on the wire connector (C) into the groove located on
□
the top of the ground stake (B).
Screw the ground stake (B) into the lamp body (A). Ensure the fixture wire on
□
the wire connector (C) stays in the center of the groove of the ground stake
(B) to avoid damage to the fixture wire.
Prepare a hole in the installation location. Use a tool such as a screwdriver
□
to prepare the installation hole to ensure that the hole is not larger than the
ground stake (B).
Install the ground stake (B) in the ground by pushing on the lamp body (A).
□
LED LOW VOLTAGE PATH LIGHT
C – Wire Connector (with 12 in. wire attached to lamp body) x1
2
Connecting the wires
WARNING: The wire connector (C) contacts have sharp edges for
piercing the main low voltage cable. To avoid injury, do not touch the
metal contacts.
CAUTION: The wire from low voltage power unit should be 12-16 AWG
type underground low Energy Circuit Cable.
IMPORTANT:
Protect the wiring by routing it in close proximity to the light fitting,
□
or next to a building structure such as a house or a deck.
The landscape wire and connector can also be hidden under stone
□
or buried under grass at a maximum depth of 6 in. (15.24 cm).
Do not install the fixture within 10 ft. of a pool, spa, or fountain.
□
Do not submerge the fixture in water.
□
Place the wire connector (C) on opposite sides of the low voltage cable
□
(not included) from the transformer (not included) where the fixture will
be located.
Align and fit the main low voltage cable vertically to the slot of the wire
□
connector (C).
Press the wire connector (C) together until it is locked around the main
□
low voltage cable. The pre-set prongs will pierce the cable insulation and
establish contact with the electrical wire inside.
Once the wire connector (C) is in place, it is recommended to wrap it with
□
electrical tape (not included).
After all fixtures are installed, turn on the transformer.
□
1
Item #1002 670 574
Model # JAO1501L-2
Use and Care Guide