IMG STAGELINE LSE-10RG Manual De Instrucciones página 9

5 Operation
1) To switch on, set the sliding switch (10)
to position 2. The fan (8) will start.
2) If no laser beams are emitted, check the
button "Music /Auto" (7) and disengage it,
if necessary.
3) Set the rotating speed of the laser dots
with the control "Motor Controller" (6).
4) To activate the flash feature, set the slid-
ing switch (10) to position 1. Set the flash
frequency with the control "Strobeflash
Controller" (9).
5) To activate the music control, engage the
button "Music /Auto" (7). Adjust the vol-
ume of the music system in such a way
that the laser beams will start flashing to
the rhythm of the music picked up via the
microphone (2). Reduce the distance
between the laser unit and the speakers,
if necessary.
6) After operation, switch off the unit with
the sliding switch (10) [position 3].
If the laser unit is not in use for a
longer period of time, disconnect the
power supply unit from the socket; even
with the laser unit switched off, the
power supply unit will have a low power
consumption.
All rights reserved by MONACOR
instruction manual may be reproduced in any form or by any means for any commercial use.
6 Specifications
Laser wavelength / power
green laser: . . . . . . . 532 nm / 30 mW
red laser: . . . . . . . . . 650 nm / 60 mW
Laser class: . . . . . . . . 2M
Power supply: . . . . . . . 5 V via
Ambient temperature: . 0 – 40 °C
Dimensions: . . . . . . . . 92 × 52 × 135 mm
Weight: . . . . . . . . . . . . 830 g
Subject to technical modification.
® INTERNATIONAL GmbH & Co. KG. No part of this
power supply unit
provided and
connected to
230 V~ / 50 Hz
GB
9