Base Assembly - Outdoor Leisure TD100A Instrucciones De Ensamblaje

Estimated assembly time: 60 minutes
Tools required:
• #2 Phillips screwdriver
• 1/2", 5/16" and 7/32" Open end wrenches
Hardware packet provided with heater may contain more parts than
needed for heater assembly.
Hardware packet contains the following items shown on pages 8
through 11 in your owner's manual):
Electronic Ignitor (1), Ignitor Wire (1), Ground Wire (1), Valve Knob
(1), Propane Tank Retention Chain (1), Retention Hook (2), D Bat-
teries (2) and AA Battery (1).

Base assemBly

1. Connect 2 base parts using 5 screws (C), 5 washers (D) and 5
nuts (E).
Nut
Washer
Screw
2. Turn base upside down. Attach 2 wheels, 2 hex bolts (A) and 2
nuts (B). Do not overtighten.
2
ASSEmbLy
Parts are referenced by designated letter throughout assembly
instructions. Hardware packet contains the following (quantity used
in parenthesis):
Description
A 2 / " Hex Bolt (2)
1
4
B 12 mm Hex Nut (2)
C 5/8" Screw (14)
D 5 mm Washer (14)
E 5/16" Hex Nut (14)
F 3/8" Screw (20)
G 7/32" Hex Nut (20)
H 3/8" Self tapping screw (34) 119620-02
3. Being careful not to scratch paint, lay cabinet base onto back side
(use foam packaging block to support rear top of cabinet base).
Align holes in bottom edges of cabinet base with holes in base.
Attach with 1 screw (C), 1 washer (D) and 1 nut (E) for each of
the 9 holes. Set assembly upright.
www.desatech.com
Part No.
HC4-18C
A
NPC-5C
D
B
119619-03
E
119600-02
C
NPC-3C
F
119619-06
NPC-1C
121450-01A
G
H