Caller Id Features - Swissvoice CP-40 Instrucciones

Pulse tone setting
You can select P (PULSE) or T(TONE) dialing mode according to the requirements
from the local telephone operator. The T/P switch is indicated in the following illustra-
tion under B.
Flash time setting
You can use the Flash feature to access services provided by your telephone operator.
The Flash time is dependent on the local telephone exchange. You can
change the setting using the switch indicated in the following illustration under C.
A - Ringer Volume Switch
B - Tone/Pulse Switch
C - Flash Time Switch

Caller ID features

If your network operator supports caller ID presentation* (CLIP), the caller's number
(if he did not not withheld his own number) is displayed before you accept the call.
To use this function, your telephone line must have active Caller Identification Presen-
tation. Check with your network operator to find out whether the function is available
and about charges, if applicable.
* Function dependent on network operator.
Display incoming calls
Display incoming call log
Redial a caller ID number
CASE 1
CP-40
C B A
Select the
caller number
OR OR
The displayed number
will be dialed
CP-40
21