Filling The Magazine; Eu Declaration Of Conformity - BEA S125-569 Manual De Instrucciones

Device-specific additional instructions for nailer
4

Filling the magazine

Ensure that nailer and fasteners are compatible (Chap. 1)
•
with each other.
Check fasteners for proper condition.
•
Actuate the locking lever 1 on the head piece and open the
•
head piece flap 2. Then open magazine cover 3 and set coil
plate to nail length on the dial 4. Insert nails into magazine.
Then close the magazine cover and headpiece flap.
5

EU Declaration of conformity

The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
S125 - 569
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 7