Chronos Manufactures Chrono Diamond Okeanos Manual Del Usuario página 12

Okeanos | Instruction Manual
minutes and on the 6 for the tenths of a second. Use the button B to reset the chronograph for the minutes,
the seconds and the tenths of a second.
Added up time measurement
Use the button A in order to start and stop the chronograph. Use the button A again in order to continue to
count the time and to stop it anew. The adding up of the time can be pursued in this way. Use the button B
to reset the chronograph for the minutes, the seconds and the tenths of a second.
Split time measurement
Use the button A in order to start the chronograph. Use the button B in order to show the split time (the
time measurement continues to run in the background). Use the button B in order to catch up the time (the
3 chronograph hands will be updated in fast mode onto the measured time which went on running). Use
the button A in order to stop the chronograph and to show the end time.
Model: 12000 Okeanos
Movement: Swiss made Quarz
ATTENTION: Do not set the date between 9.00 pm and
1.00 am as the date might not change automatically the
following day.
Date and time setting
Pull the crown carefully to position 1 and set the date by turning
it clockwi se. Pull the crown carefully to position 2 and set the
time by turning it clockwi se as well. Once finished push the
crown carefully back in to place.
Using the chronograph
Basic function
Use the button A in order to start and stop the chronograph.
You can adjust the chronograph counter on the 10 for the
EN
12