Bestway Pavillo Activebase 2 Manual Del Usuario página 3

INTRODUCTION
Proper Use
Any use other than that described or any modification
of the product is not permissible and may result in injury
and/or damage to the product. The manufacturer is not
liable for damage caused by improper use. The product
is not intended for commercial use.
Description of parts and features
A
Outer Tent Pole
2PCS
1PC
D
Peg Inner Tent
10PCS 1PC
Tent Dimensions:
Inner tent: 200cm x 105cm
Outer tent: 200cm x 120cm x 105cm
Pitching dimension: 210cm x 130cm
L
W
WARNING
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
Keep all flames and heat sources away from this tent
fabric. We recommend that you always position your
tent upwind from a camp fire. This will reduce the
chances of having embers land on your tent. In case of
fire, please find the exit to escape from the fire.
Never set up the tent near the river, under the tree of
other objective hazards.
Keep exits clear.
Make sure ventilation openings are open all the time to
avoid suffocation.
SAVE THESE INSTRUCTIONS
Choose a suitable site
Removing any sharp objects, which might damage the
groundsheet.
Owner's Manual
Model No.#68089
ACTIVEBASE 2 TENT
B
Guy Rope
4PCS
E
Carry Bag
1PC
H
E
ASSEMBLY
Setting up the tent
E
C D
WARNING: Poles contain fiber glass. We strongly
recommend wearing gloves during assembly to avoid
irritating hands.
1. Lay the inner tent <E> on the ground. Pull the four
F
corners outwards.
Note: Make sure that the channels for the poles <B>
are facing upwards.
Note: Make sure that the zip on the entrance to the
tent is closed.
2. Push the poles <B> completely into the
channels. (FIG1)
3. Stand the inner tent <E> up and push the ends of the
poles <B> into the iron bars (which are on the each
corner of the inner tent <E>. (FIG2)
4. Fasten the roof of the inner tent<E> onto the pole
junction with the sewn-on tie. (FIG2)
5. Now cover the tent with the outer tent <A> and hook
the 4 loops. (FIG3)
6. Secure the tent by pushing the tent pegs <D> into the
ground loops. (FIG3)
7. Tie one end of the guy ropes <C> onto the four corner
hoops of outer tent <A>. (FIG4)
8. Tie the other end onto the tent pegs <D> and fasten
them by inserting the tent pegs <D> into ground. (FIG4)
9. Note: Ensure that guy ropes <C> are about at an
angle of 45°
10. Do not pull the guy ropes <C> too tight.
DISASSEMBLE AND MAINTENANCE
Follow steps 1-10 in reverse order.
1. Clean the tent and remove any stains with sponge and
cool water. Please use non-detergent soap for serious
cleaning.
2. Never machine wash or machine dry the tent. Hand
wash and air dry.
3. Please allow all parts to dry thoroughly before you
repack the tent. This will prevent the formation from
mould, bad odours and discolouration
4. Stitch with thread to repair minor leaks, fabrics and
plastic sheets damage. Use ropes to connect broken
frame parts. Use tapes to repair the coating broken parts.
5. Silicone spray could be use onto zippers if stick
STORAGE
Store the tent in the stuff sack and place it in a cool, dry area
out of sunlight and away from heat sources and rodents.
3
B
FIG1
B
45°
FIG3
E
B
E
FIG2
C
FIG4