Trust SECURITY PLUS AGST-8800 Manual Del Usuario página 5

AGST 8800 OUTDOOR WIRELESS WALL SWITCH
EN
1. Open wall switch
At the bottom of the push-button is an opening. Use a fl at screwdriver to carefully remove the push
button. Remove the push button, the frame and the rubber plate of the wall switch.
2. Place battery
Insert the battery into the battery compartment. Note the + and - terminals of the battery with the +
and - symbols in the battery compartment.
3. Pair the wall switch with a receiver
To operate a receiver fi rst you must pair the wireless wall switch with the receiver. Put the receiver in
learning mode (see the manual of the receiver to activate the learning mode).
Give an ON signal on the wall switch when the learning mode of the receiver is active. The receiver
will give a confi rmation that the pairing of the wall switch has been successful.
4. Mount the wall switch
Place the backplate of the wall switch on a surface. Screw the backplate of the wall switch in place
using the supplied screws.
Place the rubber plate, the frame and the push button back on the backplate. Press the pushbutton
fi rmly in the frame of the AGST-8800 until a click is heard.
5. Operating the wall switch
5a. Dimming
1. Press the ON button to turn on the receiver.
2. Press the ON button again to activate the dimmode. The light will slowly dim in a cycle.
3. Press for the third time the ON button to secure the desired dim level.
4. Press the OFF button to turn o the receiver.
5b. Switching On/Off
1. Press the ON button to turn on the receiver.
2. Press the OFF button to turn o the receiver.
1