Prior To Operation - DeWalt D28116 Traducido De Las Instrucciones Originales

Attaching Side Handle (fi g. 5)
WARNING: Before using the tool,
check that the handle is tightened
securely.
Screw the side handle (d) tightly into one of the
holes (q) on either side of the gear case.
Mounting and Removing the Guard
(fi g. 2)
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Before
reconnecting the tool, depress and
release the trigger switch to ensure that
the tool is off.
CAUTION: Guards must be used with
this grinder.
When using the D28116, D28133 or the D28136
grinder for cutting metal or masonry a Type 1 guard
MUST be used. Type 1 guards are available at extra
cost from D WALT distributors.
E
NOTE: Please refer to the Grinding and Cutting
Accessory Chart at the end of this section to
show other accessories that can be used with these
grinders.
1. Place the angle grinder on a table, spindle (o)
up.
2. Release the clamping lock (g) and hold the
guard (c) over the tool as shown.
3. Align the lugs (k) with the notches (l).
4. Press the guard down and rotate it to the
required position.
5. If required, increase the clamping force by
tightening the screw (m).
6. Tighten the clamping lock.
7. To remove the guard, release the clamping lock.
Fitting and Removing a Grinding or
Cutting Disc (fi g. 1, 3, 4)
WARNING: Do not use a damaged
disc.
1. Place the tool on a table, guard up.
2. Fit the backing flange (i) correctly onto the
spindle (o) (fig. 3).
3. Place the disc (n) on the backing flange (i).
When fitting a disc with a raised center, make
sure that the raised centre (j) is facing the
backing flange (i).
4. Screw the threaded clamp nut (h) onto the
spindle (o) (fig. 4):
a. The ring on the threaded clamp nut (h) must
face towards the disc when fitting a grinding
disc (fig. 4A);
b. The ring on the threaded clamp nut (h) must
face away from the disc when fitting a cutting
disc (fig. 4B).
5. Press the spindle lock button (b) and rotate the
spindle (o) until it locks in position.
6. Tighten the threaded clamp nut (h) with the two-
pin spanner supplied.
7. Release the spindle lock.
8. To remove the disc, loosen the threaded clamp
nut (h) with the two-pin spanner.
Setting the Electronic Speed Control
(fi g. 6)
Turn the dial (e) to the desired level. Turn the dial
upwards for higher speed and downwards for
lower speed. The required setting is a matter of
experience.

Prior to Operation

• Install the guard and appropriate disc or wheel.
Do not use excessively worn discs or wheels.
• Be sure the inner and outer flange are mounted
correctly.
• Make sure the disc or wheel rotates in the
direction of the arrows on the accessory and the
tool.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Before
reconnecting the tool, depress and
release the trigger switch to ensure that
the tool is off.
EN GL IS H
37