Assembly And Adjustments - DeWalt D28116 Traducido De Las Instrucciones Originales

EN GLI SH
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
Anti-vibration Side Handle (fi g. 1)
The anti-vibration side handle (d) offers added
comfort by absorbing the vibrations caused by the
tool.
Keyless Guard (fi g. 1)
The keyless guard (c) allows for quick adjustment
during the application to enhance application
versatility.
Dust Ejection System (fi g. 1)
The dust ejection system (f) prevents dust pile-up
around the guard and motor inlet, and minimises the
amount of dust entering the motor housing.
Soft Start Feature
The soft start feature allows a slow speed build-up
to avoid an initial jerk when starting. This feature is
particularly useful when working in confined spaces.
Electronic Variable Speed Control
D28116, D28136
The electronic variable speed control offers added
tool control and enables the tool to be used at
optimum conditions to suit the accessory and
material.
Clutch
The torque limiting clutch reduces the maximum
torque reaction transmitted to the operator in case
of jamming of a disc. This feature also prevents the
gearing and electric motor from stalling. The torque
limiting clutch has been factory-set and cannot be
adjusted.
No-volt Release Switch
The on/off switch has a no-volt release function:
should the power be shut off for some reason, the
switch has to be deliberately reactivated.
Overload Protection
The power supply to the motor will be stopped in
case of motor overload. The power will return once
the tool has cooled down to suitable operating
temperature.
36
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 60745; therefore no
earth wire is required.
WARNING: 115 V units have to
be operated via a fail-safe isolating
transformer with an earth screen
between the primary and secondary
winding.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organization.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
2
size is 1 mm ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Before
reconnecting the tool, depress and
release the trigger switch to ensure that
the tool is off.