Braun 7 Serie Manual De Instrucciones página 15

Charging and cleaning the shaver
Insert the shaver head down into the cleaning
station. The contacts
will align with the contacts
station. Important: The shaver needs to be dry
and free from any foam or soap residue!
If required, the Clean&Renew station will auto-
matically charge the shaver. The hygiene status
of the shaver will also be analyzed and one of
the following cleaning program indicators
light up:
shaver is clean
short economical cleaning required
normal level of cleaning required
high intensive cleaning required
If the station selects one of the required cleaning
programs, it will not start unless you press the
. For best shaving results, we
start button
4
recommend cleaning after each shave.
Each cleaning program consists of several cycles,
where cleaning fl uid is fl ushed through the shaver
head. Depending on your Clean&Renew station
model and/or program selected, the cleaning
time takes up to 16 minutes. Leave the shaver in
the station for drying. It takes several hours until
remaining moisture evaporates depending on the
climatic conditions.
When the program is fi nished, the blue
will light up.
Stand-by mode
10 minutes after completing the charging or
cleaning session, the Clean&Renew station
switches to the stand-by mode: The indicators
of the Clean&Renew station turn off.
Shaver display
The shaver display
of the battery on the left, and the hygiene status
on the right. 6 dark segments are shown on each
side when the battery is fully charged and the
shaver is hygienically clean.
Battery segments:
During charging or when using the shaver, the
respective battery segment will blink. When
fully charged all 6 segments are shown. With
decreasing charge the segments gradually
disappear.
on the back of the shaver
u
in the cleaning
3
shows the charge status
z
will
5
indicator
15