Publicidad
Idiomas disponibles
Idiomas disponibles
HOw TO OPERATE
REMOTE CONTROL PREPARATION
REMOTE CONTROL PREPARATION
Inserting the batteries
Pull out
Close
• The retention period of batteries might be affected
to be shorter because of the using times of the
remote control, even less than one year.
MODE OPERATION
MODE OPERATION
Select
turn on
AUTO
HEAT
DRY
COOL
AUTO MODE - FOR yOUR CONvENIENCE
• Unit selects the operation mode according to the room
temperature.
• Once auto mode is selected, the unit will operate at the
standard setting temperature.
• To change the standard setting temperature, press
"
" or
for "
".
Room
Operation
temperature
mode
23°C & above
Cool
Below 23°C
Dry
Below 20°C
Heat
HEAT MODE - TO ENjOy wARM AIR
• In heat mode, it takes a while for the unit to warm up. The
power indicator blinks during this operation.
• Recommended temperature: 20°C ~ 24°C
COOL MODE - TO ENjOy COOL AIR
• Recommended temperature: 26°C ~ 28°C
DRy MODE - TO DEHUMIDIFy THE
ENvIRONMENT
• During soft dry operation, the indoor fan operates at low
fan speed to give a very gentle cooling operation.
• Recommended temperature: 1°C ~ 2°C lower than room
temperature.
● For heat, cool and dry modes, the range of
temperature can be selected from 16°C ~ 30°C.
F565573_en.indd
4
Insert AAA or
R03 batteries
Adjust
temperature
for
Standard
setting
temperature (+2°C)
(–2°C)
25°C
27°C
23°C
22°C
24°C
20°C
21°C
23°C
19°C
REMOTE CONTROL TRANSMITTER
• Make sure it is not
obstructed.
• Certain fluorescent lights
may interfere with signal
transmission. Please
consult your nearest
dealer.
INDICATOR
INDICATOR
Maximum distances : 8m
lCD display
Notes:
• Use a screwdriver to short the two Reset Terminals on the
back of remote control to restore the remote control's default
setting.
• Remove the batteries if the unit is not to be used for a long
period.
RECEIvER
RECEIvER
2006-11-30
13:35:43
Publicidad
