HEIDENHAIN MSE 1120 Serie Instrucciones De Instalación página 31

Connecting a network cable (MSE 1124)
MSE modules communicate with a PC through an RJ-45 connection 5 located on
the base module. Use a straight-through cable when connecting to a DHCP router. A
crossover cable may be required when connecting the workstation directly to the base
module. Refer to the documentation provided with the NIC (network interface controller)
for additional information.
To connect a network cable:
Verify power is removed from all power supply modules in the module chain
X X
With the cable connector locking tab facing up, insert the cable connector into the
X X
RJ-45 connection 5 on the module until the tab locks into place
Connecting an encoder
This product can be used with HEIDENHAIN encoders that provide TTL signals. The
connecting cable must not exceed 30 meters in length.
To connect an encoder:
Verify power is removed from all power supply modules in the module chain
X X
Connect the encoder cable connector to the encoder connection 6 on the module and
X X
tighten the cable connector screws until they are snug
All manuals and user guides at all-guides.com
5
RJ-45 connector
6
Encoder connector
26