Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 51080F
Wrenches: 19mm
Drill Bits: None
1
Qty. (6)
Flat Washer, 1/2"
2
Qty. (6)
Lock Washer, 1/2"
1.
Lower the exhaust by detaching it from the rubber isolator.
2.
Raise hitch into position and install hex bolts, lock washers and flat washers into existing weldnuts in frame, as shown above.
3.
Raise exhaust back into position and reattach to the rubber isolator.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2007 Cequent Towing Products
Installation Instructions
Toyota Sienna
Fascia
Note:
Fasteners Typical
Both Sides
Tighten all M12 CL10.9 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV1, SUV2
Frame Rail
Existing Weldnut
3 Places
(Both Sides)
3
Qty. (6)
Hex Bolt, M12 x 1.25 x 40mm
Sheet 1 of 3
51080N
Part Numbers:
51080
Max Gross
Max Tongue
Trailer WT (LB)
WT (LB)
5,000
500
3,500
350
10-9-07
Rev. A
Publicidad
Manuales relacionados para Cequent Towing Products 51080
Resumen de contenidos para Cequent Towing Products 51080
- Página 1 Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. Sheet 1 of 3 51080N 10-9-07 Rev. A 2007 Cequent Towing Products...
- Página 2 Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. Feuille 2 de 3 51080N 10-9-07 Rev. A 2007 Cequent Towing Products...
- Página 3 Este producto cumple con las especificaciones y requerimientos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York, V.E.S.C. Regulación V-5 y SAE J684. Hoja 3 de 3 51080N 10-9-07 Rev. A 2007 Cequent Towing Products...