Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 51076F
Wrenches: 16mm
Drill Bits: None
1
Qty. (4)
M10 X 1.25 X 30mm CL10.9
2
Qty. (4)
7/16 Lockwasher
1.
Raise hitch into position.
2.
Install M10 X 1.25 bolts 7/16 lockwasher and 3/16 X 1.00 X 2.00 Blocks into existing weldnuts inside vehicle frame rails.
Tighten all M10 X 1.25 CL10.9 fasteners with torque wrench to 71 Lb.-Ft. (96 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2007 Cequent Towing Products
Installation Instructions
Hyundai Santa Fe
Fascia
Weight Distributing
Wiring Access Location: SUV3, SUV4
Frame Rail
Exhaust
3
Sheet 1 of 3
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Trailer WT (LB)
Weight Carrying
Ball Mount
Existing
weldnuts
Qty. (4)
3/16 X 1.00 X 2.00 Block
51076N
Part Numbers:
51076
Max Gross
Max Tongue
WT (LB)
Not For Use With Spring Bars
3500
350
10-9-07
Rev. A
Publicidad
Manuales relacionados para Cequent Towing Products 51076
Resumen de contenidos para Cequent Towing Products 51076
- Página 1 Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. Sheet 1 of 3 51076N 10-9-07 Rev. A 2007 Cequent Towing Products...
- Página 2 Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. Feuille 2 de 3 51076N 10-9-07 Rev. A 2007 Cequent Towing Products...
- Página 3 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York, V.E.S.C. Regulación V-5 y SAE J684 Hoja 3 de 3 51076N 10-9-07 Rev. A 2007 Cequent Towing Products...