Black and Decker KS800 Manual De Instrucciones página 10

ENGLISH
How to use the Auto Select
This tool is fitted with a unique Auto Select
applications. To select the optimum speed and pendulum blade action for the type of material being cut, turn the dial (8) as
shown in the table below:
Switching on and off
To switch the tool on, press the on/off switch (2).

To switch the tool off, release the on/off switch (2).

For continuous operation, press the lock-on button (1)

and release the on/off switch (2).
To switch the tool off when in continuous operation,

press the on/off switch (2) and release it.
Sawing
Hold the tool firmly with both hands while cutting.
The shoe plate (7) should be held firmly against the material
being cut. This will help prevent the saw from jumping,
reduce vibration and minimise blade breakage.
Let the blade run freely for a few seconds before starting

the cut.
Apply only a gentle pressure to the tool while performing

the cut.
Operating the laser (fig. H - K) ('L' units only)
Installing the batteries (fig. H)
Detach the laser module (14) from the jigsaw by removing
the screw (13) and pulling the laser module forward. Insert
two new 1.5 Volt AAA alkaline batteries, making sure to
10
TM
dial (fig. G)
TM
Dial (8) to set the speed and the pendulum blade action for various cutting
Icon Application Speed
Kitchen work surfaces, Fast speed
work tops, laminate
board
Scrolling/curves/ Fast speed
craftwork, hardwoods,
decking, flooring
Plywood and wood Fast speed
panels
General timber, soft Fast speed
wood, fast rip cutting
Plastics, Perspex, PVC Medium speed
Sheet metal tin plate, Low speed
ceramic tile, fibreglass
sheet
Slow speed, precision Slow speed
start
match the (+) and (-) terminals correctly. Re-attach the laser
module (14).
Adjusting the laser side-to-side (fig. I)
Note: The laser is intended as a cutting aid and does not
guarantee a precise cut.
Warning! Do not adjust the laser with the jigsaw plugged in.
Use the laser adjustment screw (15) to align the laser line

with the saw blade if needed.
The laser visibility (power) will be reduced if the jigsaw is
overheated. The laser may not be visible when the saw is
overloaded for a prolonged period of time. The laser visibility
will gradually return to normal when the tool cools down even
when the tool is unplugged.
Warning! Do not leave the overheated laser switched ON.
Make sure that the switch is in the OFF position and remove the
batteries to remove power from the laser.
Using the laser (fig. J and K)
The laser projects the line of cut (18) on to the surface of the
workpiece.
To switch the laser on, press the button (16).

To switch the laser off, press the button (16) again.

Blade Type
General wood
Scrolling wood
General wood
General wood
General wood
General purpose
Metal or ceramic or
fibreglass blade
Choose the correct
blade for the
application