Black and Decker KS800 Manual De Instrucciones página 8

ENGLISH
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons
regularly using power tools in employment, an estimation of
vibration exposure should consider, the actual conditions of
use and the way the tool is used, including taking account of
all parts of the operating cycle such as the times when the
tool is switched off and when it is running idle in addition to
the trigger time.
Labels on tools
Warning! To reduce the risk of injury, the user must
read the instruction manual.
Electrical safety
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Additional safety instructions for non-rechargeable
batteries
Never attempt to open for any reason.

Do not store in locations where the temperature may

exceed 40°C.
When disposing of batteries, follow the instructions

given in the section "Protecting the environment".
Do not incinerate the batteries.
Under extreme conditions, battery leakage may occur.

When you notice liquid on the batteries, proceed as
follows:
- Carefully wipe the liquid off using a cloth. Avoid skin
contact.
Additional safety instructions for lasers
Read all of this manual carefully.
This product is not to be used by
children under 16.
Laser radiation.
Do not look into the laser beam.
Do not use optical tools to view the
laser beam.
8
This laser complies with class 2 according to EN 60825-

1:1994+A1:2002+A2:2001. Do not replace a laser diode
with a different type. If the laser is damaged, have the laser
repaired by an authorised repair agent.
Do not use the laser for any purpose other than projecting

laser lines.
An exposure of the eye to the beam of a class 2 laser is

considered safe for a maximum of 0.25 seconds. Eyelid
reflexes will normally provide adequate protection. At
distances greater than 1m, the laser complies with class 1
and is therefore considered completely safe.
Never look into the laser beam directly and intentionally.

Do not use optical tools to view the laser beam.

Do not set up the tool where the laser beam can cross any

person at head height.
Do not let children come near the laser.

Features
1. Lock-on button
2. On/off switch
3. Blade storage compartment cover
4. Shoe plate locking lever
5. Dust extraction outlet
6. Dust extraction adaptor
7. Shoe plate
TM
8. Auto Select dial
9. Blade support roller
10. Tool-free blade clamp
Additional features (fig. A)
Additional features may be applicable depending upon the
product purchased. The additional features applicable to the
catalogue number purchased are shown in fig. A.
Assembly
Warning! Before attempting any of the following
operations, make sure that the tool is switched off and
unplugged and that the saw blade has stopped. Used saw
blades may be hot.
Fitting the saw blade (fig. B)
Hold the saw blade (11) as shown, with the teeth facing

forward.
Push and hold the blade clamp (10) down.

Insert the shank of the saw blade into the blade holder

(12) as far as it will go.
Release the blade clamp (10).

Saw blade storage (fig. C)
Saw blades (11) can be stored in the storage compartment
located on the side of the tool.