Metra 99-7364B Instrucciones De Instalación página 3

1. Secure the pocket to the radio brackets
using the (4) #8 x 3/8" Phillips screws
provided. (Figure A)
2. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
3. Secure the radio to the bracket/pocket
assembly using the screws supplied
with the radio. (Figure B)
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
5. Secure the radio assembly to the dash
using the factory screws.
6. Clip the radio trim panel over the radio
assembly, then reassemble the dash
in reverse order of disassembly to
complete the installation.
KIT ASSEMBLY
(Figure A) (Figure B)
REV. 5/8/2018 INST99-7364B
3