Care And Maintenance - Kobalt SGY-AIR222 Manual De Instrucciones

CARE AND MAINTENANCE

ALWAYS REMOVE TOOL FROM AIR SUPPLY BEFORE PERFORMING
ANY MAINTENANCE ON TOOL.
An in-line oiler (not included) is recommended to be installed to air supply.
It will help increase tool life and keep the tool properly lubricated. The in-line
oiler should be regularly checked and filled with air tool oil as needed.
To check if the in-line oiler is properly lubricating the tool, place a sheet of
paper next to the tool's exhaust ports while holding the throttle completely
open for 30 seconds. The in-line oiler is properly set when a light stain of oil
collects on the paper. Excessive amounts of oil should be avoided. In the
event that it becomes necessary to store the tool for an extended period of
time, the tool should receive a generous amount of lubrication right before
being stored. After being well lubricated, the tool should be run for
approximately 30 seconds to ensure oil has been evenly distributed
throughout the tool. The tool should be stored in a clean and dry environment
away from the reach of children. Recommended lubricants:
Use air-tool oil or any other high grade turbine oil containing moisture
absorbent, rust inhibitors, metal wetting agent and an EP (extreme pressure)
additive. Consult your local retailer for further assistance in selecting which
air tool oil is best suited for proper lubrication.
STORAGE:
Tool must be well cleaned and lightly lubricated before storing.
Store air tool in a dry, safe place, out of the reach of children.
13