Metra 99-7617GHG Instrucciones De Instalación página 2

1. Unclip the right side of the driver's
knee bolster panel next to the
center console and let hang.
(Figure A)
Note: There is no need to
completely remove the panel.
2. Unclip and remove the (2) silver
side trim panels from each side of
the factory radio. (Figure B)
3. Unclip and remove the trim panel
below the climate control panel.
4. Remove the (4) Phillips screws
securing the climate control panel
and a/c vent panel. (Figure C)
Dash Disassembly
(Figure A)
(Figure B)
(Figure C)
®
99-7617HG
5. Remove the climate control panel.
(Figure D)
6. Remove the a/c vent panel.
(Figure E)
7. Remove the (4) Phillips screws
securing the radio, and then
remove. (Figure F)
8. If equipped with automatic
climate controls, remove the
(2) Phillips screws securing the
climate module under the radio.
This module will be reused in Kit
Assembly.
Continue to Kit Assembly
2
(Figure D)
(Figure E)
(Figure F)