Descargar Imprimir esta página

Russell Hobbs 20770-56 Manual De Instrucciones página 5

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
MAKING COFFEE
If you want coffee straight away:
1.
Ignore the clock.
Press and release the e button – the e light will show in the display.
2.
3.
Shortly afterwards, coffee will start to drip into the carafe.
4.
When it's done, the hotplate will keep the carafe warm.
If you want to stop the coffee maker while it's brewing, press the e button.
5.
If you want coffee later (timed):
1.
Set the clock to the correct time. Use the h and min buttons to set the correct time.
2.
Set the timer to the time you want to start brewing.
Press and hold the T button .
a)
b)
Use the h and min buttons to set the time you want brewing to start.
3.
If you don't press either the h or min buttons within 5 seconds, the coffee maker will revert to
"normal", and the current time will show. Press and hold the T button to start again.
When the time is programmed, release the T button then press the e button. The T icon will
4.
appear in the display.
If you want to check the program time press and release the T button. The programmed time will
5.
show for 3 seconds and then return to the time of day.
If you want to cancel the timer before brewing has started, press the e button.
6.
If you want to stop the coffee maker while it's brewing, press the e button.
7.
KEEP WARM/AUTO SHUT-OFF
1.
The coffee maker will keep the coffee warm for about 40 minutes. P and 40:00 will be displayed and
will count down in 1 minute increments.
2.
40 minutes after brewing, the P icon will go out and the coffee maker will shut down and the time of
day will be displayed.
3.
To wake the appliance, press any button.
4.
If left for much more than an hour, chemical changes start to affect the flavour of the coffee. It's best
to pour it away and make a fresh pot.
A QUICK CUP
If you want a quick cup of coffee before the brewing cycle has finished:
1.
You can remove the carafe at any time. The non-drip valve will prevent coffee dripping on to the
hotplate.
2.
To prevent the filter holder overflowing, replace the carafe on the hotplate within about 20 seconds.
3.
When you replace the carafe on the hotplate the non-drip valve opens to let any remaining coffee
through.
HOLIDAYS
If you haven't used the coffee maker for a few days, empty and rinse out the filter and holder.
Before using the BRITA water filter again take out the cartridge, clean the water tank and funnel thoroughly
and repeat the steps decribed under "PREPARING THE FILTER CARTRIDGE ".
NOTE
Don't be tempted to reheat coffee in the appliance. You'll damage the appliance and the coffee will be
undrinkable.
CARE AND MAINTENANCE
Clean the filter holder and carafe after each use. Residue from a previous brew will spoil your coffee.
1.
Unplug the appliance and let it cool.
2.
Tip the contents of the filter holder into the bin.
3.
You may clean the carafe, permanent filter, and filter holder in warm soapy water. Rinse thoroughly
afterwards to remove all traces of soap.
4.
Clean the outside surfaces of the appliance with a damp cloth.
5

Publicidad

loading