Setting Up Your Dualbrew Single Serve Coffee Maker Using The Ground Coffee Adaptor - Bella 14392 Manual De Instrucciones

14 To interrupt the brewing cycle at any time, press the
15 At the end of the cycle, the Coffee Maker and all indicator lights will automatically turn OFF
16 Allow unit to cool before removing the used capsule to discard
17 Unplug the Coffee Maker when not in use
SETTING UP YOUR DUALBREW SINGLE SERVE COFFEE MAKER USING THE GROUND
COFFEE ADAPTOR.
The ground coffee adaptor allows you to create your own favorite blend of coffee Personalize your blends by
adding a dash of cinnamon, orange peel, cardamom or vanilla bean for flavoring, to name a few options
NOTE: For best results, use medium ground coffee
WARNING: Before brewing, it is recommended the water tank be filled at least to the lowest 6-oz step To avoid
damage to your Coffee Maker, never operate your Single Serve Coffee Maker when the water tank is empty
1 Lift the water tank lid located at the top back of the unit (See Figure 1 )
2 Using the desired cup, mug, or tumbler as your measure, add water to the water tank The water tank has
an easily visible, stepped water level indicator Add water to the desired fill line to brew one cup of any
hot beverage The level indicator marks 6-oz , 10-oz , and 15-oz However, any amount of water may be
added DO NOT EXCEED the 15-oz MAX fill line
3 Lower the lid
IMPORTANT: For optimal flavor, distilled water is preferred
4 Position the cup under the nozzle and onto the center of the drip
tray cover
5 Pull the adaptor compartment's front tab up to unlock and lift
the lid
6 Choose the ground coffee adaptor Fill the reusable ground coffee
adaptor to the designated fill line, or to taste DO NOT EXCEED
the MAX fill line It is recommended to use one 1 tbsp of ground
coffee for every cup of water
7 With the handle facing front, place the ground coffee adaptor
into the adaptor compartment Slide the adaptor handle into the
grooves at the front of the Coffee Maker (See Figure 6 )
8 Press the adaptor compartment's lid down firmly An audible click
can be heard as the lid is locked firmly into position
9 Plug the Coffee Maker into a 120V AC electrical wall outlet
10 Press the button to begin the brew cycle
11 The red PREHEAT indicator light will begin to flash as the Coffee
Maker begins heating the water
12 When the water has reached the optimum temperature, the
preheat light will go out and the blue BREW light will illuminate
13 The pump will then activate and coffee will begin to stream through the nozzle
14 To interrupt the brewing cycle at any time, press the
plug from the wall outlet
15 At the end of the cycle, the Coffee Maker and all indicator lights will automatically turn OFF
16 Unplug the Coffee Maker when not in use
button Then remove the plug from the wall outlet
Figure 6
Ground Coffee
button Then remove the
9
PREHEAT
BREW