Brewing Instructions; Adjusting The Drip Tray; Setting Up Your Dualbrew Single Serve Coffee Maker Using The Capsule Adaptor - Bella 14392 Manual De Instrucciones

BREWING INSTRUCTIONS

The drip tray adjusts to two heights to accommodate shorter cups or mugs to taller travel mugs/tumblers For
taller travel mugs and tumblers, make sure the drip tray and cover are properly placed in the lower position
(See Figure 2 ) When brewing a smaller cup, raise the drip tray to the upper level to avoid splatter (See Figure 4 )

ADJUSTING THE DRIP TRAY.

1 Grasp the drip tray and cover from the base cut-outs (See Figure 2 )
2 Holding on to both pieces, slightly tilt upwards and slide out from the unit (See Figure 3 )
3 Using the tab on the back of the drip tray as your guide, again slightly tilt both pieces upwards and glide
the tabs into the upper slots on the Coffee Maker body (See Figure 4 ) Press down on the drip tray with
your hand to make sure it is firmly and properly attached before placing the cup or mug on top
Figure 2
PREHEAT
BREW
SETTING UP YOUR DUALBREW SINGLE SERVE COFFEE MAKER USING THE
CAPSULE ADAPTOR.
WARNING: Before brewing, it is recommended the water tank be filled at least to the lowest 6-oz step To avoid
damage to your Coffee Maker, never operate your Single Serve Coffee Maker when the water tank is empty
1 Lift the water tank lid located at the top back of the unit (See Figure 1 )
2 Using the desired cup, mug, or tumbler as your measure, add water to the water tank The water tank has
an easily visible, stepped water level indicator Add water to the desired fill line to brew one cup of any hot
beverage The level indicator marks 6-oz , 10-oz , and 15-oz However, any amount of water may be added
DO NOT EXCEED the 15-oz MAX fill line
3 Lower the lid
IMPORTANT: For optimal flavor, distilled water is preferred
4 Position the cup under the nozzle and onto the center of the
drip tray cover
5 Pull the adaptor compartment's front tab up to unlock and lift the lid
6 Choose the capsule adaptor With the handle facing front, place the
capsule adaptor into the adaptor compartment Slide the adaptor
handle into the grooves at the front of the Coffee Maker
(See Figure 5 )
7 Add the capsule of your choice into the capsule adaptor
8 Press the adaptor compartment's lid down firmly An audible click
can be heard as the lid is locked firmly into position Both the top
and bottom of the capsule will be punctured
9 Plug the Coffee Maker into a 120V AC electrical wall outlet
10 Press the button to begin the brew cycle
11 The red PREHEAT indicator light will begin to flash as the Coffee
Maker begins heating the water
12 When the water has reached the optimum temperature, the preheat
light will go out and the blue BREW light will illuminate
13 The pump will then activate and coffee will begin to stream through
the nozzle
Figure 3
Upper
Slots
Base
Cut-Outs
8
Figure 4
PREHEAT
BREW
Figure 5
Capsule
PREHEAT
BREW
PREHEAT
BREW