ADJUSTMENTS
Chime level adjustment:
• With the vehicle on, turn it off and leave the keys in ignition. Open the driver's door; chimes
will be heard.
• Wait 10 seconds, and then with a small flat-blade screwdriver, turn the potentiometer
clockwise to raise the chime level; counterclockwise to lower the chime level.
• When the chime is at a desired level, remove the keys from the ignition. This will lock the
chime volume at its current level.
OnStar level adjustment:
• Press the OnStar button to activate it.
• While OnStar is speaking, press the VOLUME UP or VOLUME DOWN buttons on the steering
wheel to raise or lower the OnStar level.
• If the vehicle doesn't come equipped with steering wheel controls, find the Black/Yellow
wire on the 18-pin harness.
• While OnStar is speaking, tap the Black/Yellow wire to ground. Once OnStar level is set, it
will stay at that level until the Black/Yellow wire is tapped to ground again.
4
PERSONALIZATION MENU
The vehicle must be equipped with OE steering wheel controls in order to access and change the
personalization features. If the vehicle didn't come equipped with OE steering wheel controls,
refer to the section titled No OE Steering Wheel Controls.
Note: The personalization menu can be set before the factory radio is removed. Though, the time
and date can't be adjusted in vehicles without the factory steering wheel controls.
Note: The OE Screen can be disconnected in models without factory steering wheel controls.
1. Turn off the radio.
2. Press and hold the Off Hook button on the steering wheel for 3-seconds. After 3-seconds
the personalization menu will show up on the display.
3. To scroll through the menu, use the Seek Up and Seek Down buttons on the steering wheel.
4. To make a selection, use the Source button on the steering wheel, which is the center
button between the Seek Up and Seek Down buttons.
5. Use the Off Hook button to exit the personalization menu.