Troubleshooting - Kenmore 758.15412010 Manual De Uso

Troubleshooting
TROUBLE REMEDY
• Check 120 volt power source.
Digital display not • Press power button once to turn
illuminated.
on.
Fan not operating • Raise SET humidity level if
(Digital display is desired.
illuminated).
Fan running
continuously.
Poor evaporation of
water.
Bottle empties
completely.
Bottle continues to
empty after complete
filling.
Bottle not emptying.
CF message does not
appear even when
filter is dirty or
humidifier performance
is clearly reduced.
PROBABLE CAUSE
• No Power.
• Power button has not
been depressed.
• ROOM humidity
level is not 3% or
more.
• SET humidity level is
65%.
• ROOM humidity
level has not reached
1% or more above
SET humidity level.
• CK FILTER message
flashing.
• This is normal for
initial filling.
• Air is entering water
bottle.
• Base full of water.
• A loss of power has
caused the CK FILTER
message to
prematurely reset.
• A SET humidity percentage of
65% operates fan continuously.
Adjust SET level between 25% -
6O%.
• Continue to run until desired
humidity level is achieved. This
may take up to 48 hours initially.
• Change to a fresh new filter.
NOTE: Local water varies from
area to area and under certain
conditions mineral will build up
more rapidly in the filter.
• Refill bottle for maximum run
time.
• Ensure fill cap is tight with no
interfering debris.
• Check for leak in water bottle.
• The base will hold the contents
of water bottle (1.9 gallons).
Continue to run humidifier to
deplete water from base.
• Replace filter if needed or
necessary.
• Reset humidifier.
• Humidifier is in DRY • Humidifier automatically
Fan operating slower OUT mode. switches fan speed to
than speed registered WHISPER when DRY OUT
on digital display, mode message is displayed.
• Filter not dry. • During DRY OUT mode the
Humidifier not humidifier will continue to run
shutting off during on WHISPER speed as required
DRY OUT mode. for a 2 hour period.
14