Step 4. Operating; Important; The Controls - Kenmore 758.15412010 Manual De Uso

Step 4. Operating the Controls
Where you set your desired humidity
level depends on your personal comfort
level, outside temperature and inside
temperature. A starting set point of
30% - 40% ROOM humidity is
recommended but there may be
conditions that require a different
setting.
IMPORTANT: Water damage may
result if condensation starts to form
on windows or walls. Humidity SET
point should be lowered until
condensation no longer forms. We
recommend room humidity levels
do not exceed 50%.
Recommended
When Outdoor
Indoor Relative
Temperature is:
Humidity (RH) is:
.IO°F
2°F
IO°F
20°P
.24°F
.18°C
.12°C
_6°C •
20%
250,/0
30%
35%
and above
To Operate the Controls
Digital Display
Press the power button once to display
the digital readout . L_ Initially there
is a slight delay while the electronics
calibrate.
Two bars (- -) flash during this time.
Once calibration is complete a ROOM
humidity reading between 25% - 95%
will be displayed. A flashing 20
display indicates that the room
humidity is less than 20%.
NOTE: After desired settings are
selected by the user, they remain as
long as the unit remains plugged in
and there is no power interruption. If
the unit is unplugged the original
default settings are employed.
Humidifier fan should operate at
initial start up. If it does not, refer to,
"Fan not operating (digital display is
illuminated)" in the "Troubleshooting"
section on page 14 of this manual.