Kenmore 758.15412010 Manual De Uso página 8

Operating the Controls (cont'cL)
Speed Button O
This humidifier is equipped with a 4-
speed fan control. Each push of the
speed button advances the mode
through the settings of HIGH, MEDIUM,
LOW, WHISPER, and AUTO. The
selected setting is displayed on the
digital readout. The higher the setting,
the faster water is evaporated and
released into the air. WHISPER is the
quietest setting and is provided for
conditions that do not require a rapid
evaporation rate.
Fan Speed Display Fan Speed Button
How Auto Control Works
The AUTO setting allows the humidifier
to manage it's speed range to maintain
your desired humidity setting. It will
automatically cycle to the most efficient
speed to achieve the desired humidity.
Here is how the fan will operate:
° HIGH speed will engage if
room humidity is 15% or
greater RH (Relative Humidity)
below the SET point.
• MEDIUM speed will engage if
room humidity is 15 - 10% RH
below the SET point.
• LOW speed will engage if room
humidity is 10 - 5% RH below
the SET point.
• WHISPER speed will engage if
room humidity is 5% RH or less.
If the room humidity is not
increasing at the current fan speed
during a 15 minute period, the fan
speed increases to the next higher
speed until the humidity SET point is
reached.
NOTE: The humidifier may run on
HIGH for an extended period of
time if the actual room humidity is
extremely low.
Humidity Control
This button allows you to adjust the
humidity to suit your needs. This
humidifier will automatically cycle
on and off as required to maintain
the selected setting. The readout
displays both actual (ROOM) and
desired (SET) humidity percentage
(%) settings when humidity control
button is pressed. The ROOM
readout has a range of 25% to
95%. If the room humidity level is
equal to or less than 20% the
display will show a flashing 20. The
SET readout has a range of 25% to
65% and is adjusted in increments
of 5%. Initially depressing the
humidity button will display the
current humidity setting. Each
additional press of the button
increases the setting by 5%. A SET
point of 65% operates the
humidifier continuously regardless
of the ROOM reading. The
humidistat that senses the readings
is located on the power cord. Ensure
that this humidistat is free from
obstruction.
,..= .....
Y P Y Humidity Control Button