Alarm Management - CASATELLI LEONARDO 12T Generalidades - Advertencias - Instalación - Mantenimiento

13

ALARM MANAGEMENT

If an anomaly occurs in the operation, the following procedure is activated:
1) acoustic alarm (beep);
2) one of the following system LEDs lights up:
3)
Press and hold the
CODE
ERROR/WARNING
E001
Defective control panel
E002
Remote control communication signal error
E004
Communication error
Ignition failure error
E101
E106
Pellet probe alarm
E108
Pressure or thermal safety error
E110
Temperature probe malfunction
E111
Fume probe malfunction
Scheduled maintenance warning.
A002
A004
Low battery
A005
Hall sensor malfunction
----
Stove cleaning
----
Ignition failure error
If the error code is "
• the stove has cooled down
• the burn pot is clean and free from ash residue or pellets
• the burn pot is correctly positioned in its seat
•
"cancel" key to display the error code:
DESCRIPTION
E108
", manually re-arm the thermostat on the back of the stove before resetting the alarm
004778340 - 16/07/2020
;
POSSIBLE CAUSES
Defective control panel
Defective control panel
Connection cable between board and control panel
interrupted or disconnected.
this error
Pellet quality
Faulty ignition system
Dirty burn pot
Pellet probe disconnected or faulty
Dirty fume evacuation system
Worn sealing gaskets
Problems of overheating of the pellet tank
Defective air probe
Defective fume temperature probe
Periodically, the stove requires maintenance by a
specialist technician
The back-up battery (mod. CR2032) on the electronic
board is low *
Hall sensor on fumes fan disconnected or faulty
Combustion chamber, burn pot or dirty fume evacuation.
Detached or blocked pressure detection tubes.
Blocked combustion air intake.
No pellets: Ignition resistor faulty;
Worn gaskets; Incorrect burn pot position
LED
for a few seconds.
Fig. 13
49