Tabla de contenido
Publicidad
Circulation
CAUTION
Thermo Scientific
External
The plumbing connections for external circulation are located on the rear
of the immersion circulator.
application.
side). The connections are 16 mm O.D. Remove the union nuts and plates
to install the 8 mm or 12 mm hose barbs and clamps supplied with the
circulator.
Remote Temperature
Sensor (See next page)
Insulation - Used
for G50 Low Temp
Operation only
Outlet Flow
Note G50 circulators are supplied with 1
tion (4 total). For low-temperature operation, install a single piece of
insulation on each of the pump lines.
To prevent damage to the circulator's plumbing, use a 19 mm
backing wrench when removing/installing the external connections.
is the outlet flow to the external application (supply
USB Port
(See next page)
is the return flow from the external
Connections (Typical)
/
" (32 mm) pieces of insula-
1
4
Section 3 Installation
Multifunction Port
(See next page)
Return Flow
3-7
Publicidad
Tabla de contenido
