Tabla de contenido
Publicidad
Section 4 Operation
Daily Start Up
Before starting the circulator, double check all communication,
electrical and plumbing connections.
The blue LED on the immersion circulator illuminates to indicate it is in
stand by mode.
If so, press
. The blue LED goes out. If Auto Restart is enabled the
circulator starts. If Auto Restart is not enabled, or if the blue LED is not
illuminated, use the Initial Start Up procedure described on the previ-
ous page.
The Auto Restart feature is described later in this Section.
Note When using oil as a reservoir fluid, we recommend running the
circulator at 95°C for 15 minutes to remove any moisture in the fluid.
Thermo Scientific
4-3
Publicidad
Tabla de contenido
