Ubbink 7524430 Manual De Instrucciones página 18

UBBINK
®
Swimming pool 430 - H120 cm
Warranty conditions:
• The pool must be assembled within 48 hours after opening the package. However, if you are forced to keep your pool unpacked for an inde-
finite period of time before installation (e.g. after-sales service request), it is essential to keep all wooden parts flat in a dry and ventilated
area, and to restrap them firmly to maintain the benefit of the warranty.
• Assembly of the pool on a flat, smooth, level concrete slab in accordance with the dimensions indicated in the instructions is mandatory for
the validation of the warranty.
• Our warranty is limited to the replacement of defective parts. It does not in any way imply a claim for compensation or damage and interest.
• The general warranty does not apply in the following cases:
- Use of equipment not in accordance with our instructions.
- Damage caused by improper handling during and after assembly or any modifications made to structural components without the
manufacturer's consent.
The pump:
UNDER WARRANTY
- Electrical problem: 2 years under normal use conditions (from the date of purchase of the consumer)
The liner:
UNDER WARRANTY
- 2-year warranty: Sealing and holding of welds under normal use conditions (from the date of
purchase by the consumer)
Example of warranty coverage
Filtration:
UNDER WARRANTY
- 2-year warranty on: tank, drain plug, collar, multi-way valve, pump-filter connection pipe (from the
date of purchase of the consumer)
POOL WARRANTIES
NOT UNDER WARRANTY
- Deterioration by abrasion or corrosion (particularly in the context of water treatment by salt elec-
trolysis)
- Damage due to faulty connection or improper replacement of the cable and/or power plug
- Equipment dismantled or reassembled by a third party
- Breakage of parts (pump base, prefilter cover, fluted tip...) – use of the dry pump
- Damage to the pump due to its immersion (flooding of the technical room for example) – damage
due to freezing
NOT UNDER WARRANTY
- Deformations of the liner that has been without water for more than 24 hours (never completely drain
your pool) – tasks related to algae growth
- Tasks related to the decomposition of foreign bodies in contact with the liner
- Stains and discolourations resulting from the action of oxidising products
- Colour stability and wear due to friction of the material on various surfaces
- Liner tears below the hung rail resulting from liner movement or poor water line maintenance
- Holes, snags, tears or cuts
- Tasks resulting from overdosing or improper handling of treatment products (poured directly into
the water)
- Folds or damage resulting from improper installation of the liner
NOT UNDER WARRANTY
- Leakage problems due to operating pressure exceeding the maximum permissible pressure (see
filter instructions)
- If sand with grain size less than 0.6 mm is used
- Damage or inconvenience resulting from improper assembly or failure to comply with our assembly
instructions
- frost damage
18