Software Setup; Software Application - Hama 00053192 Manual De Instrucciones

Attaching WBA Audio and Video to TV
1. Connect a VGA cable to the appropriate VGA port
on the Wireless Beamer Adapter.
2. Connect the other end of the cable to the appropriate
VGA port (D-SUB) on the television, projector
or monitor.
3. Connect the audio cable to the Line Out port, and
to the TV's Audio in port or other speakers.
Attaching Device to Network
1. If your broadband router is close to your Wireless
Beamer Adapter, connect an Ethernet cable from an
available Ethernet port of the router to the WAN port
of the WBA device.
Attaching WBA to Power
1. Plug the power cord into the WBA and power outlet.
2. You should see the following welcome screen about
a minute after powering up the WBA device (you may
have to change the TV input setting using the TV
remote control).

4. Software Setup

Installing WBA Software
1. Before you install the WBA software, remove any
earlier version installed on your PC by clicking on
WBA Uninstall located under Windows Start -> All
Programs.
2. Insert the Software CD that came with the WBA.
Click "Install Utility", and the Setup program should
automatically start.
3. The software will automatically start to install.
When Installing Mirror Display driver, this will cause
a black screen to appear for a few seconds.
4. Only Windows 2000: Click Reboot when the installation
is complete.
Windows XP and Vista: Click Finish when the install
is complete.
Uninstalling WBA Software
1. Click Start and navigate to All Programs -> WBA
2. Click Uninstall and the software removal process
will begin.
3. When the uninstallation process is finished, reboot
your PC.

5. Software Application

Configuring WBA Software
When the WBA software connects to the device for the
very first time after initial installation, it automatically
launches the Configuration Wizard. The Configuration
Wizard allows you to select various options for Internet
Connections as well as personal preferences and
protection settings such as user passwords and display
access codes. You can also change your WBA settings
using the WBA Configuration Wizard any time you run the
software subsequently.
11