Technical Data - Beta 1838S Instrucciones

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO

TECHNICAL DATA

MAIN LIGHT
TOP LIGHT
BATTERY SPECIFICATIONS
POWER SUPPLY VOLTAGE
CHARGE INPUT
PROTECTION DEGREE
OPERATING TEMPERATURE
CHARGING MODE
To charge the lamp, open the USB socket on the ON/OFF switch.
that the mains voltage is compatible with that of the charger as stated in the TECHNICAL DATA table.
While the lamp is being charged, the LED lights next to the USB socket will be blinking. The lamp will
be fully charged when the 3 LED lights will remain green. The lamp can then be disconnected from the
power supply and the USB socket guard closed.
Charge level
Turning the lamp on will cause the 3 LED lights next to the ON/OFF switch to light up, to indicate the
charge level.
- 3 green LED lights: 100% charge
- 2 green LED lights: 60% charge
- 1 green LED light: 20% charge
USE
• Press the ON/OFF switch to enable the lamp.
• Press once to enable the TOP light.
• Press a second time to enable the MAIN light in the eco mode.
• Press a third time to switch the lamp to the normal mode,
• Press a fourth time to switch the lamp to the full power mode.
After the lamp has been on for 5 seconds in the selected mode, pressing the ON/OFF switch will cause
it to be SWITCHED OFF. When the lamp is enabled again by pressing the ON/OFF switch, it will go on
in the last selected mode.
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personnel only.
For such jobs, you can contact Beta Utensili S.P.A.'s repair centre.
DISPOSAL
The crossed-out wheelie bin symbol on the equipment or packaging means that the product should be
collected separately from other types of urban waste at the end of its useful life.
Any user who is going to dispose of this tool can:
6
COB LED
eco mode ~ 150 lm - max 7.5h
normal mode ~ 350 lm - max 3.5h
full power mode ~ 700 lm - max 2h
SMD LED
~200 lm - max 5h
Li-Ion 3.7 V, 2600mAh, 9.62 Wh
100 - 240V ~ 50/60Hz
DC 5V -1A (USB-C)
IP65, IK 09
-10°C ÷ +40°C
EN I