Publicidad
w
e
r
q
4) Reinstall the filter element in the cup.
t
q
5) Tighten the ring nut approximately an
207052
6) Run the engine and check the filter
1 Filter element
2 O-ring
3 Filter cup
4 Ring nut
5 Filter housing
NOTE:
If any water is in the fuel, the red ring in
the fuel filter unit will float. If so, remove
the cup and drain the water.
EMK56010
CHECKING WATER TRAP UNDER
ENGINE OIL TANK
There is a trap at the bottom of the engine
oil tank. If water or foreign matter is visi-
w
ble in this trap, consult a Yamaha dealer.
1 Trap
2 Engine oil tank
213021
4-13
Make sure the O-ring is in position in
the cup. Insert the cup and O-ring into
the filter housing. Screw the ring nut
onto the filter housing until the ring is
lightly seated.
additional 1/4 turn until ring nut is
tight.
Align one of the four larger ring nut
tabs into the slot of the locking tab.
Install the locking tab bolt and tight-
en.
and lines for leaks.
GB
Publicidad
Capítulos
