DeWalt DWEN302 Traducido De Las Instrucciones Originales página 29

Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
conductor size is 1.5 mm 2 ; the maximum length
is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of
injury, turn unit off and disconnect
tool from power source before
installing and removing accessories,
before adjusting or changing set-ups
or when making repairs. Be sure the
trigger switch is in the OFF position. An
accidental start-up can cause injury.
Side Handle (fi g. 1)
WARNING: To reduce the risk of
personal injury, ALWAYS operate
the tool with the side handle properly
installed. Failure to do so may result
in the side handle slipping during tool
operation and subsequent loss of
control. Hold tool with both hands to
maximize control.
A side handle comes assembled with the
DWEN302. The side handle (g) can be fitted to suit
both right-hand and left-hand users.
TO ADJUST THE SIDE HANDLE
1. Loosen the side handle (g) by turning it
counterclockwise.
2. Rotate the side handle to the desired position.
3. Tighten the side handle by turning it clockwise.
TO CHANGE SIDES
For right-hand users: slide the side handle
clamp over the chuck, handle at the left.
For left-hand users: slide the side handle clamp
over the chuck, handle at the right.
Forward/Reverse Lever (fi g. 1)
The forward/reverse lever (c), located above the
trigger switch (a), is used for withdrawing bits from
tight holes and removing screws.
To reverse the motor, release the trigger switch
FIRST and then push the lever to the right (viewed
when holding the drill in the operating position).
After any reversing operations, return lever to
forward position.
Mode Selector (fi g. 2)
NOTICE: Tool must come to a
complete stop before activating the
mode selector button or damage to the
tool may result.
Select the required operating mode by sliding the
mode selector (i) to the corresponding symbol.
DRILL-ONLY MODE
Use drill-only mode for wood, metal, and
plastics.
HAMMER-ONLY MODE
Use hammer-only mode for simultaneous
rotating and impacting for masonry, brick
and concrete.
Setting the Drilling Depth (fi g. 3)
1. Insert the required drill bit into the chuck.
2. Loosen the side handle (g).
3. Fit the depth adjustment rod (h) through the
hole in the side handle clamp.
4. Adjust the drilling depth as shown in figure 3.
5. Tighten the side handle.
Keyed Chuck (fi g. 1, 4, 5)
The DWEN302 features a keyed chuck (d).
TO INSERT A DRILL BIT OR OTHER ACCESSORY
1. Open the chuck jaws by turning collar by hand
and insert the shank of the bit about 19 mm
(3/4") into chuck. Tighten the chuck collar by
hand.
2. Place chuck key in each of the three holes, and
tighten in clockwise direction. It's important to
tighten chuck with all three holes.
ENGLISH
27