Página 1
WatchGuard ® AP 225 HW Model: C-110 DRAFT Quick Start Guide WatchGuard® Technologies, Inc.
Página 2
1. Go to www.watchguard.com/activate 2. Log in to your WatchGuard account, or create a new account*. *If you create a new account, return to www.watchguard.com/activate after you finish the account creation process. 3. Type the serial number for your device.
Página 3
Connect to the WatchGuard Wi-Fi Cloud • Select the discovered Access Point and click Pair. To connect to the WatchGuard Wi-Fi Cloud, log in to the WatchGuard Support Center or go to • Configure radio settings for each radio. Click Save.
Página 5
• Firebox DHCP 将 设备连接至 的可信赖或可选接口,并开启 。 * Si vous créez un nouveau compte, retournez sur la page www.watchguard.com/activate à la fin du 有关静态 IP 地址的更多信息,请参见 Fireware 帮助。 processus de création de compte. • 如果网络不支持以太网供电 (PoE) , 请连接到可选电源适配器或 供电器 (单独销售) 。...
Página 6
WatchGuard Wi-Fi Cloud sur ces ports : HTTP TCP 80/443 et UDP 3851. • Connectez-vous à l'interface utilisateur Web Fireware et assurez-vous que le protocole DHCP est Si vous disposez d'une appliance Firebox, la politique WatchGuard Wi-Fi Cloud ouvre les ports nécessaires. activé sur l'interface à laquelle le périphérique AP se connecte.
Página 7
Ports mit WatchGuard Wi-Fi Cloud-Services kommunizieren kann: HTTP TCP 80/443 und UDP 3851. AUSWÄHLEN DER AP-VERWALTUNGSMETHODE Wenn Sie eine Firebox haben, werden die entsprechenden Ports durch die WatchGuard Wi-Fi Cloud-Richtlinie geöffnet. DRAFT Beim Kauf Ihres AP-Geräts haben Sie sich für eine entsprechende Verwaltungsmethode •...
Página 8
2. Accedere al proprio account WatchGuard, oppure crearne uno nuovo*. aktiviertem DHCP. * Se si crea un nuovo account, tornare a www.watchguard.com/activate dopo aver terminato la Weitere Informationen zur Verwendung einer statischen IP-Adresse finden Sie in der Fireware-Hilfe. procedura di creazione dell’account.
Página 9
WatchGuard Wi-Fi Cloud sulle porte seguenti: HTTP TCP 80/443 e UDP 3851. • Accedere all’interfaccia utente web Fireware e verificare che sull’interfaccia alla quale si collega Se si dispone di un dispositivo Firebox, la policy WatchGuard Wi-Fi Cloud apre le porte necessarie. il dispositivo AP sia abilitato il protocollo DHCP.
Página 10
• Power over Ethernet DRAFT パワーアダプタ または、 インジェクタ (別売り)を接続してください。 デバイスの購入時、二つの管理方法のうち一つを選びます。このガイドではその両方の基本設定 AP デバイスの電源を入れた後、電源及び Ethernet(LAN) ランプが緑色に点灯するまで数分間お 方法を記載しています。設定方法の選択にあたっては、 デバイスが梱包されていた箱表面の • 待ちください。 このランプ状態は、AP デバイスがオンラインであり、WatchGuard Wi-Fi Cloud ステッカーをご参照ください。 と 通信可能であることを意味しています に接続する WatchGuard Wi-Fi Cloud に接続するには、 にログインするか、下記をクリッ WatchGuard Wi-Fi Cloud WatchGuard Support Center ゲートウ ェイ WatchGuard Wi-Fi Cloud Firebox クしてください。...
Página 11
が有効になっているオプション インター フェイスに 2. WatchGuard 계정으로 로그인하거나 새 계정을 만듭니다*. • AP Firebox DHCP 接続します。 * 새 계정을 만들 경우 계정 생성 과정을 마친 후 www.watchguard.com/activate 로 固定 IP アドレスに関しては Fireware ヘルプ をご参照ください。 돌아가십시오. 3. 장치의 일련 번호를 입력합니다. お使いのネットワークが (...
Página 12
• AP 장치의 전원을 켠 후 전원 표시등과 이더넷(LAN) 표시등이 녹색으로 켜질 때까지 몇분 동안 Wireless Controller 확인란을 선택합니다. 기다립니다. 이 상태는 AP 장치가 온라인이고 WatchGuard Wi-Fi Cloud와 통신할 수 있음을 • AP 장치가 페어링된 후 Firebox가 AP 장치에 대해 사용할 AP Passphrase를 입력합니다.
Ethernet (LAN) se iluminen en color verde. Esto indica que el dispositivo AP está en línea y se puede comunicar con la nube Wifi de WatchGuard. Conéctese a la Nube Wifi de WatchGuard Para conectarse a la Nube Wifi de WatchGuard, inicie sesión en el Centro de soporte de WatchGuard Nube Wifi de WatchGuard Controlador Inalámbrico https://login.watchguard.cloudwifi.com...
Página 14
2. Faça login na conta WatchGuard ou crie uma nova*. Fireware). * Se for criar uma conta nova, acesse www.watchguard.com/activate depois de concluído o • Si su red no es compatible con Alimentación a través de Ethernet (PoE), conecte el inyector PoE o processo de criação de conta.
Página 15
- Lembre-se de conferir a conectividade do dispositivo AP com a internet e se ele consegue • Faça o login na interface de usuário da web do Fireware e confira se a interface do dispositivo AP se comunicar com os serviços do WatchGuard Wi-Fi Cloud nestas portas: HTTP TCP 80/443 e tem DHCP ativado.
Sicherheitshinweise. • When removing or installing an appliance, follow the general installation safety instructions. Disclaimer WatchGuard shall not be held liable if the end user alters, modifies, or repairs any WatchGuard hardware appliance.
AVISO DE SEGURIDAD FCC CERTIFICATION Todos los productos WatchGuard están diseñados y probados para satisfacer estrictos requisitos de This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) seguridad. Estos requisitos incluyen la homologación de productos de seguridad y otras normas de This device may not cause harmful interference, and (2) this device must accept any interference received, cumplimiento global.
Página 20
CE Notice harmful interference to co-channel mobile satellite systems; The CE symbol on your WatchGuard Technologies equipment indicates that it is in compliance (ii) the worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement with the Electromagnetic Compatibility (EMC) directive and the Low Voltage Directive (LVD) of the set forth in Section 6.2.2(3) shall be clearly indicated.
Página 21
Dynamic Frequency Selection (DFS) for devices operating in the bands 5250- 5350 MHz, 5470-5600 MHz and 5650-5725 MHz. Brazil ANATEL Sélection dynamique de fréquences (DFS) pour les dispositifs fonctionnant dans les bandes 5250-5350 Este equipamento opera em caráter secundário, isto é, não tem direito à proteção contra interferência MHz, 5470-5600 MHz et 5650-5725 MHz.
EU country legislative requirements is seamless for our product’s end users. If you have a EN 301 489-17 V2.2.1:2012 WatchGuard product that is at its end of life and needs to be disposed of, please contact WatchGuard Electromagnetic compatibility and Radio spectrum Matters (ERM); ElectroMagnetic Compatibility (EMC) Customer Care Department at: standard for radio equipment;...
Página 23
• WatchGuard does not import more than 1 metric ton per year of a substance as defined by REACH. • WatchGuard products are non-chemical products that are not designed to release any substance under normal and reasonably predictable application.
Declaration of Conformity WatchGuard Technologies Inc. hereby declares that the product(s) listed below conform to the European Union directives and standards identified in this declaration. Product (s): Wireless Access Point, WatchGuard Model AP225 EU Directive(s): Radio & Télécommunications Terminal Equipment (1999/5/EC) Low Voltage (2006/95/EC)