Klarstein ICEFESTIVAL CUBE Manual Del Usuario página 21

TROUBLESHOOTING
1. Please note, if a power failure occurs due to disconnection of the power cord, or
the off power button has been pushed off during an ice making cycle, small ice
chips may formed and lodge in the automatic shovel causing it to jam. If this occurs,
the ice chips may be removed by disconnecting the power cord and gently pushing
the shovel to the rear of the cabinet and removing the ice chips, then restarting.
2. Please restart the ice maker by pressing ON/OFF. If the Ice shovel does not push
the Ice into the Ice collector after the formed Ice drops from the evaporator finger
while at the same time the M light is on, check to see if the water tray is horizontal
or balanced. If not then adjust by pressing the Ice shovel lightly with your finger.
Then re-start the Ice maker.
Problem
The compressor works
abnormally with a Buzzing
noise.
Conditions for Ice making
Cycle are right but no ice
is made.
The lights of ice full and
add water come at in the
same time.
Machine keeps
running,but the water is
warmer than the normal
water.
Reason
The voltage is lower than
recommended
Refrigerant leaks. Sealed
system is blocked.
Water tray is blocked by
ice cube.
The magnetic valve is
broken.
Solution
Stop the Ice maker and do
not restart until the voltage
is normal.
Call for service.
Clear the ice cube under
the ice shovel pull out
the plug and insert It
again then press the ICE
button, 3 minutes later
the machine will restart
automatically.
Replace the magnetic
valve.
EN
21