Fiap Wallskim Active Slim Manual De Instrucciones página 5

FIAP WallSkim Active Slim
Scope of delivery
1x skimmer-casing with lid out of stainless steel
1x trap basket for waste, with handle out of stainless steel
1x skimmer-weir out of stainless steel, including floating body
2x EPDM gasket-rings suitable for stainless steel flange
1x stainless steel flange
10x flat head screw out of stainless steel, with cross slot M5 x 14 mm
Description
For the mechanical water treatment of garden-ponds, close to nature swimming-ponds and swimming-
pools is the FIAP WallSkim Slim a professional extraction system for water surfaces.

Recommended pump-capacity 4.500 l/h - 20.000 l/h

Outstanding suction-capacity

Ideal for gravity-filtersystem and pumped filtersystem

Easy installation and maintenance through flanging of foil
 Alternative installation into the masonry (wall thickness up to 26 mm)

With FIAP Aqua Active Profi or FIAP Aqua Active Eco pumps compatible

Pipe-connection DN150

Material stainless steel
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30;
9
www.fiap.com
FIAP WallSkim Active Slim
Assembly
For an optimal degree of efficiency the device for the suction of the water-surface (FIAP WallSkim
Active Slim) should be mounted against the main wind direction. The main wind direction is mostly the
east bank. So the dirt-particles can float perfectly in the direction of the suction-opening. To support
this process you can create additional water-streaming. During installation make sure that no plants or
rocks are placed in front of the suction-opening. They can reduce the efficiency of the device for the
suction of the water-surface (FIAP WallSkim Active Slim).
Installation according to the sequence of the pictures
1. Use a skimmer-flange for marking.
2. When made out of metal sheet, plastic material or fiber glass drill with a drill machine a hole
in each of the four corners, inside the marking of the skimmer-flange. If it is a pond-foil then
use a sharp knife for this.
3. With a jigsaw you cut the metal-sheet, plastic material, fiber glass and so on out.
4. If necessary use a file to true and strip the cut.
1 2
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30;
soft materials hard materials
3 3
www.fiap.com
10