4. Unclip and remove the (2) side trim
panels at the front of the center console,
and then remove the (1) Phillips screw
exposed behind each panel. Tip: Pull
out on the front sides of the console to
release for later steps. (Figure E)
5. Slide both of the front seats forward and
then remove the (2) 12mm bolts from
the rear sides of the center console. Slide
the seat back once done. (Figure F)
6. Unclip and remove either the front
console pocket or heated seat controls,
depending on options available.
(Figure G)
Continued on next page
DASH DISASSEMBLY
(Figure E)
(Figure F)
(Figure G)
REV. 2/3/2021 INST99-7639HG
3