Harbor Breeze 00598 Manual De Instrucciones página 5

ASSEMBLY INSTRUCTIONS
6. Install hanger ball on top of downrod (E) into
mounting bracket (A) opening. Rotate fan until slot on
hanger ball engages the tab on mounting bracket (A).
DANGER: Be careful when aligning tab to slot.
If not fully engaged, the fan could fall, which could
result in serious injury or death.
Important: Do NOT use this fan with dimmer switch
or variable speed wall control. Using a dimmer switch
or variable speed wall control will damage the fan.
ON
ON / OFF NO Variable NO Dimmer
switch speed wall
control
7. Insert the receiver from the remote pack (L) into the
mounting bracket (A) with the flat side towards the
ceiling. Connect BLACK wire from receiver to BLACK
wire from ceiling. Connect WHITE wire from receiver
to WHITE wire from ceiling. Connect all GROUNDED
(GREEN) wires together from fan to GREEN/
GROUNDED wire from ceiling. Connect the male plug
from fan to female plug from the receiver together.
NOTE: BLACK wire is hot power for fan and light kit.
WHITE wire is common for fan and light kit. GREEN
wire is grounded wire. lf house wires are different
colors than referred to above, stop immediately and
consult a professional electrician to determine proper
wiring.
8. Twist wire ends together and screw wire connectors
(AA) on in a clockwise direction. Tape wire
connectors (AA) and wires together with electrical
tape (not included).
NOTE: After making connections, make sure bare
wire or wire strands are NOT visible. Place green
and white connections on opposite side of box from
black and blue connections. Splices should be turned
upward and pushed carefully up into outlet box.
Hardware Used
AA
Wire Connector
6
E
A
switch
7
Black
White
Grounded/Green
Grounded/
Green
8
AA
x 4
8
ASSEMBLY INSTRUCTIONS
9. Slide canopy (B) up against ceiling and over two
screws on mounting bracket (A). Rotate canopy (B)
clockwise to lock it into place. Tighten two screws.
Tab
Slot
10. Slide canopy cover (C) over two screws and rotate
clockwise until it locks.
NOTE: Adjust screws as necessary until canopy (B)
and canopy cover (C) are snug.
A
White
Blue
Black
11. Attach blade (G) under blade arm (F) using three
decorative nuts (CC) and three blade screws (DD).
Repeat for remaining blades (G), blade arms (F),
decorative nuts (CC) and blade screws (DD).
Hardware Used
Decorative Nut
CC
Blade Screw
DD
9
B
10
11
x 15
x 15 + 1 extra
H
CC
9
EE
A
Screws
C
DD
G
F
B