Energy Saving Tips; Connecting The Cooler - Dometic CF35 Instrucciones De Uso

CF35, CF40, CF50
6.2

Energy saving tips

• Choose a well ventilated installation location which is protected against direct
sunlight.
• Allow warm food to cool down first before placing it in the cooling device to
keep cool.
• Do not open the cooling device more often than necessary.
• Do not leave the cooling device open for longer than necessary.
• Defrost the cooler once a layer of ice forms.
• Avoid unnecessary low temperatures.
6.3

Connecting the cooler

Connecting to a battery (vehicle or boat)
The cooler can be operated with 12 V
A
NOTICE! Danger of damage!
Disconnect the cooler and other consumer units from the battery before
you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
For safety reasons the cooler is equipped with an electronic system to prevent the
polarity reversal. This protects the cooler against short-circuiting when connecting to
a battery.
➤ Plug the 12/24 V connection cable (fig. 1 2, page 3) into the DC voltage
socket and also into the cigarette lighter or a 12 V or 24 V socket.
Connecting to a 120 V AC mains (e.g. in the home or office)
D
DANGER! Danger of electrocution!
• Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
• If you are operating your cooler on board a boat from a mains
connection of 120 V
breaker between the 120 V AC mains and the cooler.
Seek advice from a trained technician.
EN
g g
or 24 V .
w
, you must install a residual current circuit
Operation
13