Operating - Rapid PCN45 Manual De Instrucciones

3. COMPRESSED AIR SYSTEM
Maxi 8 bar
Mini 5 bar
Regulator
Oiler
Quick Quick Quick Plug
Plug Coupler (Optional)
Quick
Coupler
(Optional)
Filter

4. OPERATING

4.1 Loading
• The tool shall not be connected to pressure which potentially exceeds recommended
operating pressure by 10%.
• In the case of higher pressures, a pressure reducing valve which includes
a downstream safety valve shall be built into the compressed air supply.
• Use only clean, dry regulated compressed air at recommended pressure.
• Connect the tool to the compressed air supply using suitable pressure
hose equipped with quick-action connectors.
• The compressor plant shall be adequately dimensioned in terms of
pressure output and performance (volumetric flow) for the consumption
which is to be expected.
• Line sections which are too small in relation to the length of the line (pipes
and hoses), as well as overloading the compressor, will result in pressure
drops.
• Easily accessible water separators should be installed at the lowest points.
• Connecting points for the tools should be fitted with a compressed air servicing unit
(filter/water separator/oiler) directly at the junction point.
• Oilers must be checked on a daily basis and if necessary topped up with the
recommended grade of oil (see technical specification).
• Where hose lengths of over 10 m are used, the oil supply for the tool cannot be
guaranteed, it is therefore recommend that 2 to 5 drops (depending on the loading
of the tool) of the recommended oil (see technical specifications) should be added
via the air inlet of the tool, or an oiler attached directly to the fastener driving tool.
• Disconnect the tool from air supply before loading the tool.
1. Open the magazine
• Pull down door latch and swing the door, then swing magazine cover open.
2. Adjust nail holder.
The nail holder can be adjusted up and down to three settings. Set the position of the
nail holder according to nail length. The nail will not feed smoothly unless the magazine
is correctly adjusted. To change the setting pull up the post, located in the center of the
magazine, and twist to the correct level.
3. Load the coil of nails.
Place the coil of nails over the post in the magazine. Uncoil enough nails to reach the
feed pawl, place the first nail in front of the feed pawl into the driver channel and place
the second nail between the teeth of the feed pawl. The nail heads must be in the slot in
the nose.
4. Close the magazine
Close the magazine cover and swing the door closed. Be sure that the door is fully
latched and locked into place. The nailer is now ready to operate.
7