Lubrication And Maintenance - Rapid PCN45 Manual De Instrucciones

5. LUBRICATION AND MAINTENANCE

6. TROUBLESHOOTING
• The tool should be serviced properly and at regular intervals in accordance with the
manufacturer's instructions.
• While tool is disconnected from air supply, make daily inspection to ensure free
movement of safety yoke and trigger.
• Only use supplied oil or oil recommended in the technical specifications on the tool.
Squirt oil lightly with 2 or 5 oil drops into air inlet.
• Clean magazine, pusher, and safety yoke periodically.
• Lubricate the sliding parts of the magazine occasionally to prevent wear.
• Keep the tool clean and inspect for wear. Do not use flammable cleaning solutions.
• Do not use detergent oil or additives or solvent as they will damage o-rings and
rubber parts.
• Drain compressor tanks and hoses daily.
• Make sure all screws and caps are securely tightened at all times. Loose screws result
in unsafe operation and parts breakage.
• Disconnect air from tool before all repairs.
• Stop using the tool immediately if any of the following problems occur.
NOTE: Serious personal injury could occur.
• Any repairs or replacements must be done by a qualified person or an authorized
service center only.
9