Yamaha Soavo-1 Manual De Instrucciones página 5

ATTACHING THE FRONT COVER
The speaker and the front cover are packed separately.
To attach the front cover, line up the six salients (magnet)
on the reverse side of the front cover with the six
corresponding pegs.
Notes
• When the cover is not attached, take care not to
touch the speaker units with your hands or to exert
excessive force with tools.
• There are magnets on the reverse side of the front
cover. Do not place the front cover close to objects
that might be affected by magnets, such as TVs,
clocks, magnetic cards, diskettes etc. when you don't
use it.
SPECIFICATIONS
Type ...................................... 3-way 4-speaker bass reflex
Driver ...................................... 16 cm (6-1/2") cone woofer
3 cm (1") aluminum dome tweeter
Impedance ................................................................... 6 Ω
Frequency Response ................. 35 Hz to 50 kHz (–10 dB)
Nominal Input Power .................................................. 50 W
Maximum Input Power ............................................. 200 W
Sensitivity .................................................. 89 dB/2.83 V/m
Crossover Frequency ................................... 500 Hz, 5 kHz
Dimensions (WxHxD) ....................... 349 x 1051 x 487 mm
(13-11/16" x 41-3/8" x 19-3/16")
Weight ................................................. 27 kg (59 lbs. 8 oz.)
• Specifications subject to change without notice due to
product improvements.
• Care should be taken not to exceed the input power
values noted above.
Taking care of the speaker
When you wipe this unit, do not use chemical solvents
(ex. alcohol or thinners etc.); this might damage the
finish. Use a clean, dry cloth. For heavy dirt, dampen a
soft cloth in detergent diluted with the water, wring it out,
and then clean this unit up with a soft cloth.
speaker system
Magnetic shielding type
13 cm (5") cone midrange
to 100 kHz (–30 dB)
5
En