Fisher & Paykel SleepStyle Auto Guía De Uso Y Cuidado página 10

A-8 ENGLISH
4. Fill the water chamber with water.
Peel back the chamber seal on the left-hand side of the
water chamber. Fill the water chamber with water up to
the maximum water-level line, as indicated on the side and
inside of the water chamber.
Warnings
To avoid burns:
Do not fill the water chamber with hot water as this may
lead to airway burns.
Cautions
To prevent water damage to the device:
• Do not use if the water chamber is damaged.
• Do not fill the chamber housing with water. Only place
water in the water chamber.
• Do not fill the water chamber above the maximum
water-level line.
• Replace water before each use.
• Do not fill the water chamber while it is in the device.
• Do not use the device with an empty water chamber
unless the humidity level is set to 0.
• Do not add aromatic-based or scented oils to the
water chamber as these oils can cause damage to the
device.
General:
Use distilled water to reduce residue build-up on the
chamber base. This will extend the life of your water
chamber.
5. Secure the chamber seal.
Unfold the chamber seal back onto the water chamber.
Push down in the finger holds to secure it in place.
Cautions
To prevent water damage to the device:
Do not use the device without the chamber seal fitted to
the water chamber.
6. Put the water chamber back into the device.
Place the water chamber back into the device. Push the
device lid down until the lid latch clicks into position.
7. Connect the mask to the breathing tube.
Holding the mask and the other end of the breathing tube,
connect the mask swivel firmly into the breathing tube.