Package Content - ONOFF SEATPOST PIJA Montaje Y Guía Del Usuario

INTRODUCTION
Onoff PIJA Dropper Post, the adjustable seatpost in ICR ( Internal Cable
Routing ) Version, providing riders with a way to adjust saddle height with-
out tools. Freely and easily positioning your saddle height according to the
terrain you meet. The remote lever & MICRO adjustment offer quick and
safe seat position applied with reliable and robust technology – virtually
No Play!
Unique, elegant and an easy to assemble head design.
Please read through these instructions thoroughly and carefully before
installing and operating seatpost and always keep this manual for your
further reference.

PACKAGE CONTENT

1
2
1. Dropper seatpost
2. Cable housing
3. Cable
4. Clamp lever (1x)
INSTALATION
-
Ensure the post outer diameter conforms to the inner diameter of the
seat tube of your frame.
-
Please plan the cable routing on the bike fi rst and make sure the
length of cable and cable housing you need.
-
You need a suitable frame with a 8mm hole to allow the inner cable
to run through.
-
Install your saddle on the clamp head with 5,, hex wrench to tighten
at a torque of 8-10Nm.
-
Insert the post into the frame and make sure the post's minimum
length should be inserted into bike frame, tighten the seatclamp
according to manufacturer's recommended torque and maximum
torque of 7Nm.
-
In case there is a protection cap included with the post, please refer
to Protection cap installation before following below cable assembly
process.
12
3 4
5. Nut and screw set
6. Cable end cap
7. Protection cap (optional)
5 6
min insert length
7